Buying guide

Philips GoZero Sparkling Water Maker Guide

Updated on · By the Fizz Butter team

The Philips GoZero sparkling water maker comes in two models: the metal ADD4902 and the plastic ADD4901. Both carbonate a 1-liter bottle in 2 to 3 seconds per press, run without electricity and take standard 60-liter screw-in CO2 cylinders that aren't included.

On this page (8 sections)
  1. Which Philips GoZero model should you buy?
  2. How does the GoZero actually carbonate water?
  3. What CO2 cylinder does the Philips GoZero take?
  4. Which bottles fit the Philips GoZero?
  5. Is the GoZero a good fit for a small kitchen?
  6. How does the GoZero compare with other soda makers?
  7. How do you set up and care for the GoZero?
  8. Which GoZero model is right for you?

The Philips GoZero sparkling water maker turns cold tap water into sparkling water or soda in seconds, and it's a manual machine, so no outlet is needed. There are two models in the lineup, and the differences between them matter less than most buyers expect.

This guide covers how the GoZero works, which model suits which kitchen, and the bottles and cylinders you'll need to keep the fizz going. If you're comparing it against other brands, our roundup of the best carbonated water makers puts it in context.

For the general buying checklist, start with how to choose a carbonated water maker.

Which Philips GoZero model should you buy?

Pick the ADD4902 if you want the metal body; pick the ADD4901 if you want to spend less on the same carbonation. The two machines share a carbonation process, a 1-liter bottle and the same cylinder and bottle requirements.

The real differences are material and weight. The ADD4902 is stainless steel and weighs 2.4 pounds.

The ADD4901 is plastic and weighs 2 pounds. Neither takes electricity, so both work on a counter, a patio table or a picnic setup.

Both are compact enough for a small kitchen. Philips gives the footprint as 9.4 inches deep and 7.8 inches wide, with a height of 18.6 inches.

That's a narrow strip of countertop, about the same space as a kettle and a mug side by side.

The metal model: Philips ADD4902 Soda Maker

The ADD4902 is the one to choose if the machine will sit out on the counter all the time. The stainless steel body looks more like an appliance than a gadget, and its 2.4-pound weight keeps it planted when you press down to carbonate.

Its carbonation control is simple: press once for a gentle sparkle or repeat two or three times for a bolder fizz. That's the same sequence on both machines, so the metal version isn't harder to use.

The package includes one soda maker and one 1-liter BPA-free carbonating bottle with an airtight lid. Philips says the airtight lid helps the bottle keep drinks fizzy longer, which matters if you carbonate a full liter and don't finish it in one sitting.

The plastic model: Philips ADD4901 Soda Maker

The ADD4901 is the lighter, plastic-bodied version of the same machine. It's the better fit if you want to move the soda maker between the kitchen and the patio, or if you'd rather not spend the extra on a metal body.

Everything functional is shared with the metal model. You twist the bottle in, press the button, and carbonate for 2 to 3 seconds per press.

Philips describes the sound from the valve as your cue that the press has registered.

The 2-pound weight is light enough to carry with one hand. The trade-off is the plastic shell, which won't feel as solid as stainless steel if the machine lives in a busy kitchen.

How does the GoZero actually carbonate water?

You fill the bottle with cold water, twist it into the machine and press the button down until the valve sounds. Carbonation takes 2 to 3 seconds per press, and each press adds more fizz.

The process is entirely manual. There's no compressor, no cord and no screen.

The machine releases CO2 from the cylinder into the sealed bottle, and the pressure dissolves the gas into the water.

Philips gives three basic steps in its instructions. Fill the carbonating bottle with clean water between the marked filling lines.

Press the button down firmly until you hear a sound from the valve. Repeat as needed to reach the carbonation level you like.

The filling line matters. Overfill the bottle and there's less headspace for the gas to work with; underfill it and you get less sparkling water per cylinder.

Cold water also holds carbonation better than warm water, so chilled tap water gives the crispest result.

What does the button press feel like?

The press is a short, firm push rather than a long hold. Philips puts the carbonation time at 2 to 3 seconds for each press, so a full liter takes seconds, not minutes.

The valve sound is your signal to stop. Press once for a light sparkle, or press two or three times for a stronger fizz.

The same button drives both models, so the feel is the same whichever body material you choose.

Because there's no electricity, the machine works anywhere you can carry it. That's a real advantage over countertop carbonators that need a power point, especially for outdoor entertaining.

What CO2 cylinder does the Philips GoZero take?

The GoZero takes standard 60-liter screw-in CO2 cylinders. Philips says these are easily exchanged at most popular retailers, and one cylinder carbonates up to 16 gallons of water.

The cylinder is not included with either model. That's the first thing to sort out before the machine arrives, because you can't carbonate without one.

Philips notes it in the product details for both the ADD4902 and the ADD4901.

The exchange model keeps costs down over time. You buy the first cylinder outright, then swap the empty for a full one at a retailer that carries the standard size.

Philips says one cylinder replaces up to 120 single-use plastic bottles, which is the environmental case for the machine as much as the cost case.

How long a cylinder really lasts depends on your habits. A household that presses once per bottle will stretch a 60-liter cylinder much further than one that presses three times every time.

If you carbonate daily and like bold fizz, plan on more frequent exchanges.

For a broader look at how refills work across brands, our CO2 and refills section covers cylinder types, exchanges and what to expect. If you're weighing the GoZero against a metal machine with a more design-led look, the Aarke sparkling water maker models are the usual comparison.

Which bottles fit the Philips GoZero?

Only Philips Quick Twist carbonated bottles fit the GoZero. The compatible models are ADD916/37, ADD910BKOQ/37 and ADD910WHOQ/37.

A standard soda bottle or another brand's carbonating bottle won't lock in.

This is the most common source of confusion for new owners. Soda makers pressurize the bottle, so the connection has to be engineered for it.

Philips builds the Quick Twist fitting specifically for its own bottles, and the machine's instructions say to use those models only.

Each machine ships with one 1-liter BPA-free carbonating bottle and an airtight lid. That's enough to start, but a second bottle is worth having if you drink sparkling water every day.

Carbonate one bottle while the other chills in the fridge.

The spare bottle set: Philips Carbonating Bottles ADD916/37

The ADD916/37 set gives you two 1-liter bottles so you always have a chilled one ready. They have a stainless steel base and cap, and Philips says the quick-connect design seals airtight to keep drinks fresh longer.

Philips lists these bottles as compatible with the ADD4902BKOQ/37, ADD4902WHOQ/37, ADD4901GROQ/37 and ADD4901BKOQ/37. That covers both GoZero models in this guide.

The bottles are BPA-free and reusable.

One practical note from Philips: the bottles are hand wash only and not dishwasher safe. Rinse before first use, and keep them out of the dishwasher to protect the sealing parts.

Is the GoZero a good fit for a small kitchen?

Yes. The GoZero is a narrow manual soda maker with a small counter footprint.

Philips gives the footprint as 9.4 inches deep by 7.8 inches wide by 18.6 inches high, so it needs less counter depth than many kitchen appliances.

Height is the number to check first. At 18.6 inches, the machine needs clearance above it for the bottle to twist in and out.

Measure from the counter to the underside of your upper cabinets before you commit to a spot.

Depth matters too. The machine needs room behind and in front for the bottle to seat and for you to press down.

A 9.4-inch depth is modest, but it still needs clear space on all sides.

The manual design helps in small kitchens in another way. There's no cord to route, no outlet to reach and no compressor noise.

You can tuck it into a corner and pull it out only when you want a drink.

Where should the GoZero live?

Put it on a stable, level surface with clearance above for the bottle. A countertop beside the sink is the natural spot, since you fill the bottle with cold water right there.

Keep it away from the edge. Pressing down on the button pushes the machine into the counter, so it needs to sit flat and secure.

Philips describes the quick-twist bottle as attaching in seconds, which makes the machine easy to use in a hurry.

If you entertain outdoors, the light plastic ADD4901 is the easier one to carry to the patio. The metal ADD4902 is heavier but stays put on a windy table.

How does the GoZero compare with other soda makers?

The GoZero's edge is simplicity and price, not features. It's a manual machine with one button and no electricity, which puts it in the same class as basic lever and button carbonators rather than the premium electric models.

The comparison shoppers usually make is against the Aarke. An Aarke machine has a more design-forward metal body and a lever-based carbonation action.

The GoZero uses a button press instead. For a closer look at how Aarke's models differ from each other, see our Aarke sparkling water maker guide.

If you want a machine that looks like a permanent countertop appliance, the premium end of the market is worth a look. Our roundup of the best premium sparkling water makers covers the metal-bodied options.

The GoZero sits below that tier on price and finish.

What the GoZero does well

The one-button carbonation is genuinely easy to learn. Press once for a light sparkle or repeat for more fizz, and you're done in seconds.

There's no learning curve beyond that.

The no-electricity design is a practical plus. It works during a power cut, on a patio and at a campsite.

That's a feature electric carbonators can't match.

The 1-liter bottle size suits one or two people. A couple drinking sparkling water with dinner will finish a liter easily.

A larger household might want the spare bottle set to keep up.

Where it gives ground

The bottle lock-in is the biggest limitation. You can only use Philips Quick Twist bottles, so you can't grab a generic bottle from the cupboard.

Spares are a separate purchase.

The lack of a cylinder in the box is the second thing to plan for. Philips sells the CO2 cylinder separately, so the first shop includes the machine plus a cylinder.

The plastic ADD4901 body won't suit buyers who want a metal appliance on show. That's the main reason to step up to the ADD4902.

How do you set up and care for the GoZero?

Setup takes minutes: fit a 60-liter screw-in cylinder, fill the bottle with cold water to the line, twist it in and press. Most of the care routine is about the bottle, not the machine.

Start by rinsing the carbonating bottle before first use. Philips says to rinse and clean it before use, and to fill cold water only up to the marked line.

Fit the CO2 cylinder into the machine following the instructions that come with it. The cylinder screws in, and Philips says the standard 60-liter size is exchanged at most popular retailers.

Twist the filled bottle into the machine until it seats. Press the button down firmly until you hear the valve sound, then repeat two or three times if you want bolder fizz.

Daily care and cleaning

Rinse the bottle after each use with clean water. Philips says the bottles are hand wash only and not dishwasher safe, so wash them by hand and let them air dry.

Wipe the machine body with a damp cloth. The metal ADD4902 handles this easily; the plastic ADD4901 is just as simple to wipe down.

Keep the airtight lid clean and dry between uses. Philips says the airtight lid helps keep drinks fizzy longer, so a clean seal matters for the next bottle.

Storing the machine and cylinders

Store cylinders upright in a cool spot, away from heat. Follow the cylinder maker's instructions for storage and exchange.

The machine itself doesn't need much space. Its 9.4 by 7.8 inch footprint means it can stay out on the counter without crowding the kitchen.

If you carbonate in batches, keep a filled bottle in the fridge. Cold sparkling water holds its fizz better than warm, and the airtight lid helps once the bottle is open.

Which GoZero model is right for you?

For most buyers, the metal ADD4902 is the better long-term pick; the plastic ADD4901 suits tighter budgets and buyers who move the machine around. Both carbonate the same way, so the decision comes down to material and weight.

Choose the ADD4902 if the machine will sit on the counter and you want a stainless steel body that looks built to stay. Its 2.4 pounds keep it steady during the press.

Choose the ADD4901 if you want the same carbonation for less, or if you'll carry the machine between the kitchen and the patio. At 2 pounds it's the lighter of the two.

Whichever model you pick, buy a 60-liter CO2 cylinder at the same time and consider the two-pack of spare bottles. The cylinder gets you carbonating on day one, and the spare bottle keeps a chilled liter ready.

The philips gozero sparkling water maker is a simple, manual way to make sparkling water at home without electricity. If you want the wider field first, compare it with the best carbonated water makers and the premium picks before you decide.

Frequently asked questions

Does the Philips GoZero sparkling water maker include a CO2 cylinder?

No. The CO2 cylinder is sold separately, and both models take standard 60-liter screw-in cylinders you can exchange at most popular retailers.

Budget for the first cylinder before your machine arrives so you can carbonate on day one.

How long does one CO2 cylinder last on a Philips soda maker?

Philips says one 60-liter cylinder carbonates up to 16 gallons of water. In practice that depends on how many presses you use per bottle, so a light-sparkle household will get more bottles out of a cylinder than someone who presses three times every time.

Can I use other brands' bottles in the Philips GoZero machine?

No. The machine only takes the Philips Quick Twist carbonated bottles, model numbers ADD916/37, ADD910BKOQ/37 and ADD910WHOQ/37.

A generic soda bottle won't lock in safely, so keep spare Philips bottles on hand.

Is the Philips GoZero soda maker electric?

No. Both the ADD4902 and ADD4901 are manual machines with no power cord.

You twist the bottle in and press down on the button, so you can use them on a patio or at an outdoor gathering without an outlet nearby.

What's the difference between the ADD4902 and the ADD4901?

The main difference is the body material and weight. The ADD4902 is stainless steel at 2.4 pounds; the ADD4901 is plastic at 2 pounds.

Both have the same carbonation process, bottle compatibility and 1-liter capacity, so the choice is mostly about look and feel.